Article by: RobRed

Applicable Models: 1998-2007 / HZJ105L GNMNS (1HZ GX MTM SF LHD LUB DSL2 GEN)

Adaptable Models: 1998-2002 / 100 Series Land Cruiser or LX470 with cable throttle

In some international severe weather markets (Russia) Toyota offered an in cabin hand throttle option for the 105 series Land Cruiser. This option is very useful for managing engine speed during a warm up but has additional useful functions such as managing RPM for extended winching operations or the use of high output accessories such an on-board welder or compressor system.

The 105 Series has a different drivers lower instrument panel with a cutout and recess for the hand throttle. You could install the hand throttle without using the factory panel by simply mounting the knob in a convenient position such as below the ignition switch but if you want the full look you can add the knee panel. Note that the 105 series doesn’t have the four “slits” below the ignition switch. These “slits” are for the mounting (behind) of the AC interior temperture sensor.

Don’t expect to run into your USA Toyota dealer and find these on the shelf, these are “Cold Area” or “Russian Spec”. The part numbers (p/n) are scraped from Russian spare parts sites and are believed to accurate however when hunting these down you should verify correctness.

Parts needed for Adding Hand Throttle:

• 78183D – Clamp, Accelerator Control, Cable p/n 78183-60150
• 78407 – Arm Sub Assy, Throttle Control p/n 78407-60020
• 78410 – Cable Assy, Throttle Control p/n 78410-60120
• 78411A – Knob, Throttle Control Cable p/n 78411-22010
• 78481 – Clamp, Throttle Wire p/n 78481-60010
• 78120G – Rod Assy, Accelerator Pedal p/n 78120-60250

Common Parts:

• Ring, E – 96160-00400
• Cushion – 90541-06008
• Nut, Hexagon – 90170-11006

78180P – Cable Assy, Accelerator Control – 78180-60570 This is the main throttle cable for RU HDJ 105. You already have one of these.

Look Here for Complete How-To Article on Installing the Hand Throttle